The Evolution of self-tapping into plastic materials
Self-tapping fastener for thermoplastics
Optimised locating point
Depth independent installation torque
Support with complete CAE based designing
Excellent process safety
Standardisation potential
DELTA PT®
High load capacity direct fastening into plastic material
High load capacity direct fastening into plastic material
High fatigue strength
Safety due to high tensile and torsion strength as well as vibration resistance
A wide range of possible tightening torques
Easy design engineering with the EJOT® DELTA CALC prognosis programme
Lightweight design: use of shorter fasteners and/or smaller diameters possible under certain conditions
DELTA PT® DS
The self-tapping fastener for thermoset.
Safe and reliable direct assembly into thermosets
Saving potential through standardisation – one type of screw for thermoplastic and thermoset
Easy assembly due to good application of the screw
Smaller hole depth possible compared to screws with a milled cutting edge
Larger flank coverage at the same insertion depth compared to screws with a milled cutting edge
Enables weight reduction goals to be realised in all kinds of components and assemblies
EJOFORM®
Flexibility with multi-stage forming technology.
Bespoke cold formed fastening elements for a virtually unlimited range of applications
100% matching possible to the application
Enables reductions in materials and inventory costs
Large cost-saving potential due to multi-functionality
Simplification of assembly
Replacement of machined parts
ALtracs® Plus
The self-tapping screw for light metal
The self-tapping screw for light metal
Suitable for lightweight construction with the optimised thread geometry facilitating the use of smaller and shorter screws, while retaining consistently high strength values
High clamp loads and long term stability, even under high dynamic and thermal stress
Up to 40% cost savings through omission of work steps for screw and component
Easy design engineering with the EJOT® ALtra CALC® prognosis programme
High vibration resistance without additional safety elements
High assembly safety due to low installation and failure torque
Where a repair is needed, a metric screw can be used in its place
Lower installation and higher stripping torques enable safer assembly with common pneumatic and electric screwdrivers
EJOT Covers
Development and production of functional plastic parts with integrated contacts.
Housing
Development and production of functional plastic parts with integrated contacts.
Sensor Housings
Development and production of functional plastic parts with integrated contacts.